Floral Crown

Needed:

  • Scissors
  • Small sharp knife
  • Flower wire

Cut some branches of the bush — you need the branches to be quite long as they form the base of the crown.

Starting on one side, take one of the longest branches, and start slowly adding smaller branches so the form a half circle

Tie together with flower wire and leave to one side.

Keep going until you have most of the branch covered. Do the same for the other side.

Shape the branches into a circle, creating a crown.

Leave the ‘naked’ branches on the back and tie them together forming a circle.

If you see small areas where the crown is uneven, add some more flowers, tied together with flower wire.

Trim the crown, and get rid of any leaves, wire, or flowers sticking out.

Unless otherwise stated, the content of this page is licensed under Creative Commons Attribution-ShareAlike 3.0 License